Gather all needed ingredients and read through the brew steps. | |
Collect 7.00 gallons of water in your brew kettle and begin heating. | |
Steeping Grains |
|
Pour the following ingredients into a mesh bag:
|
|
Steep grain for 20 minutes or until water reaches 170 F | |
Remove mesh bag and discard | |
Bring water to a boil | |
Fermentables |
|
To avoid scorching, remove kettle from heat source | |
Add the following fermantables to the kettle:
|
|
Return to a boil | |
Hops and Kettle Additions |
|
As soon as you reach a boil, set timer for 90 minutes
|
|
Cooling |
|
When the 90 minute boil is complete, cool the wort to 68 F as rapidly as possible. Use a wort chiller or place the kettle in an ice bath. | |
While the wort cools, sanitize the fermenting equipment - fermentor, lid or stopper, air lock, funnel, etc. along with the yeast pack and a pair of scissors. | |
Pour in the cooled wort into your fermentor. Leave any thick sludge in the bottom of the kettle. | |
Add more cold water as needed to bring the volume to 6.00 gallons. | |
Using a hydrometer, take a gravity reading from a sample of your wort. This should be close to the estimated O.G. (original gravity) of 1.077. | |
Seal the fermentor and aerate the wort. Rock fermentor back and forth for a few minutes or use an aeration stone. | |
Yeast |
|
Add yeast once the temperature of the wort is 78 F or lower. Use the sanitized scissors to cut off a corner of the yeast pack, and carefully pour the yeast into the primary fermentor. | |
Seal the fermentor with stopper or lid. Add water into the sanitized airlock and then insert the airlock into the rubber stopper or lid. | |
Fermentation |
|
Allow beer to ferment at the recommended temp for the recommended number of days. |
Created with MIBrew from Michigan Brew Supply